Install a Dash Cam (Standard Instructions)

Use the following steps for standard installation of dash cam models manufactured prior to the CM33 and CM34. For specific instructions to install a CM33 or CM34 model Samsara Dash Cam, refer to the CM33/CM34 Dash Cam Installation Guide.

Dual-Facing AI Dash Cam (CM32)

Front-Facing AI Dash Cam

To install a dash cam, you will need:

After you have the necessary tools and components, follow the general steps below to install your dash cam or review the supplemental Dash Cam (CM) Install Guide (PDF).

1. Identify the mounting location and thoroughly clean with the provided wipe. For optimal visibility and to ensure accurate AI Event Detection, position the camera below the rear view mirror and above the windshield sweep. For regional and AI positioning recommendations, see:

   • Dash Cam Position Recommendations and AI Detection Best Practices

   • Mounting Position Recommendations for Dash Cams (US)

   • Mounting Position Recommendations for Dash Cams (UK)

2. Peel off the protective sheet and firmly press the dash cam against the windshield. Make sure there are no large bubbles between adhesive and glass.

3. Adjust the camera angle so that the camera hangs perfectly vertical, then tighten both screws using the hex key.

4. Run the cable across the top of the windshield and secure it using the cable clips or tuck it under the glass seal around the windshield.

5. Plug the camera into the USB port of the Vehicle Gateway (VG).

   For best results, the cable should not wrap around the gateway or cross the diagnostics cable.

6. After the dash cam is installed in the vehicle and connected to a VG, verify the installation:

   1. Verify that the new dash cam displays in the Samsara dashboard (settings ( ) > Devices > Cameras.

      

   2. To confirm appropriate placement, Test Dash Cam Positioning.